IBM 4693, Installation And Operation Manual, Page: 22 / 74

Created February 23, 1997
Securing I/O Devices to the
System Unit
1
Press in on the locking lever at left side of
system unit so that its lugs engage the
keyboard, printer, and fillers.
2
Check to be sure that the locking lever
securely holds the I/O devices and fillers to
the system unit.
Installing the Alphanumeric
Display
1
Plug display cable 4 to the display and route
it through the yoke and post as shown. The
end of the cable that has the round core
connects to the display.
2
Spread the arms of the yoke open slightly
and slide the display into the yoke.
3
Route the cable through opening in the
system unit at base of display.
4
Attach the display post to the system unit,
using two plastic thumbscrews. The notch in
the base of the post faces the rear.
5
The display is installed. Install any other I/O
devices at this time, otherwise go to
“Installing the System Unit Rear Cover” on
page 1-21.
Locking Lever
Front
Yoke
Post
Core
1-10
Installation and Operation for POS I/O Devices