IBM 4693, Installation And Operation Manual, Page: 25 / 74

Created February 23, 1997
Installing the Shopper Display
1
Route the cable through the post or arm.
2
Firmly press the display into the post or arm
until it snaps into place.
3
If the display is mounted on an arm, press
the cable into two notches on the underside
of the arm.
4
Route the cable through the opening in
system unit at the base of the display.
5
Attach the display post or arm to the system
unit, using two plastic thumbscrews.
Note: The notch in the base of post faces
the rear.
6
The display is installed. Install any other I/O
devices at this time, otherwise go to
“Installing the System Unit Rear Cover” on
page 1-21.
Post or Arm
Chapter 1. Installing Input/Output Devices
1-13