IBM 4693, Installation And Operation Manual, Page: 17 / 74

Created February 23, 1997
Installing the Cash Drawer and the System Unit
1
Place the cash drawer in the desired
location.
2
Place the system unit on top of the cash
drawer, if the unit is integrated.
3
Open the rear cover on the cash drawer and
remove it.
4
Connect the cash drawer cable to the 3A or
3B socket on the rear panel of the system
unit.
5
Connect the other end of the cable to the
rear of the cash draw (socket 3).
6
Connect the AC power cord to the system
unit.
Do not plug the other end of power cord
to an outlet yet.
7
Route the power cord down toward the
bottom of the cash drawer.
8
Install the cash drawer rear cover.
Note: Other models may vary.
9
The cash drawer is installed. Install any
other I/O devices at this time, otherwise go
to “Installing the System Unit Rear Cover” on
page 1-21.
Cover
Release
Button
(Both Sides)
Pin Power Cord
Rear Cover
Hole
3
Chapter 1. Installing Input/Output Devices
1-5