IBM 3746-900, Installation Manual

Page: 214 / 276

Removal the 3746-900 attached to a 3745-X1A
Preparing Machines for Shipment
Step 1. ____ Remove the end cover on the right side. Loosen the four retaining
screws using a 5/16" socket from inside the machine. Then lift the cover
from the slotted holes on the frame and pull it towards you.
Step 2. ____ Re-install the end cover at the right side of the 3745 base frame,
3746-A11, or 3746-A12, depending on the 3745 configuration.
Step 3. ____ Re-install all parts removed from frames, covers, and doors.
Step 4. ____ Re-install the shipment bars on the upper and lower ends of the
basic board (and expansion board if any, see Figure 2-2 on page 2-3)
Step 5. ____ Pack the machine using the pack/unpack instructions.
Step 6. ____ Pack the customer's parts and documentation in one package and
label it: "Customer Package".
Step 7. ____ Pack other parts and all maintenance documentation in another
package and label it: "Maintenance Package". Hold for use by IBM
Service Representative.
Step 8. ____ Coil all removed cables and store them alongside the machine.
Step 9. ____ Complete the removal records according to existing procedures.
Inform the IBM Branch Office that the machines are ready for shipment.
Testing the 3745
Step 1. ____ Run CDF verify (see step 2 on page 5-2 for details).
Step 2. ____ Run the IOC and DMA diagnostics (see step 5 on page 5-5 for
details).
Step 3. ____ Ask the customer to re-start and check the network.
12-4
3746-900: Installation Guide