IBC Water AS14100MP-CL, Installation & Operating Instructions Manual

Page: 23 / 54

AS14100MP-CL Page
23
Brine Line Connection
The brine line comprises a pick up air check
assembly installed in the brine wall in the cabinet and
connected by tubing to the brine elbow on top of the
valve.
Note: Make sure that all fittings and connections are
tight so that premature checking does not take place.
Premature checking occurs when the ball in the air
check seals before all brine is drawn out of the brine
tank. Refer to the
Troubleshooting section in this
manual for additional information.
Brine Tank Overflow Line Connection
In the event of a malfunction, the tank overflow
connection directs overflow to the drain instead of
spilling on the floor where it could cause water
damage. Complete the following steps to connect the
overflow fitting to the brine tank:
1. Locate the fitting overflow on the side of the brine
tank.
2. Attach a length of 1/2in (1.3cm) tubing (not
supplied) to the fitting and run to the drain.
Note:
Do not elevate the overflow line higher than 3in
(7.6cm) below the bottom of the overflow fitting. Do
not tie into the drain line of the control unit. The
overflow line must be a direct, separate line from the
overflow fitting to the drain, sewer or tube. Allow an
air gap as in the drain line connection.
Overflow Line Connection