iB-WRX150NE
150M Extreme Wireless-N Router
- 36 -
Channel -
This field determines which operating frequency will be used. The default channel
is set to 6. It is not necessary to change the wireless channel unless you notice interference
problems with another nearby access point.
Mode -
Select the desired mode. The default setting is Automatic (802.11b/g/n) mode.
11Mbps
(802.11b) -
Select if all of your wireless clients are 802.11b.
54Mbps
(802.11g) -
Select if all of your wireless clients are 802.11g.
150Mbps
(802.11n) -
Select only if all of your wireless clients are 802.11n.
Mixed mode
(802.11b/g) -
Select if you are using both 802.11b and 802.11g wireless clients.
Automatic
(802.11b/g/n)
-
Select if you are using a mix of 802.11b, 11g, and 11n wireless
clients.
Select the desired wireless mode. When 802.11g mode is selected, only 802.11g wireless
stations can connect to the Router. When 802.11n mode is selected, only 802.11n wireless
stations can connect to the AP. It is strongly recommended that you set the Mode to
Automatic (
802.11b/g/n)
, and all of 802.11b, 802.11g, and 802.11n wireless stations can
connect to the Router.
Channel width -
Select the channel width from the pull-down list.
The default setting is
automatic, which can adjust the channel width for your clients automatically.
Note:
If 11Mbps(802.11b
) only
, 54Mbps(802.11g
) only
, or
Mixed mode
(802.11b/g
)
is selected in
the
Mode
field, the
Channel Width
selecting field will turn grey and the value will become
20MHz, which is unable to be changed.
Max Tx Rate -
You can limit the maximum tx rate of the Router through this field.
Enable Wireless Router Radio -
The wireless radio of this Router can be enabled or
disabled to allow wireless stations access.
Enable SSID Broadcast -
When wireless clients survey the local area for wireless networks
to associate with, they will detect the SSID broadcast by the Router. If you select the
Enable
SSID Broadcast
checkbox, the Wireless Router will broadcast its name (SSID) on the air.
4.7.2 Wireless Security
Choose menu “
Wireless
→
Wireless Security
”, you can configure the security settings of your
wireless network.
There are five wireless security modes supported by the Router: WEP (Wired Equivalent Privacy),
WPA (Wi-Fi Protected Access), WPA2 (Wi-Fi Protected Access 2), WPA-PSK (Pre-Shared Key),
WPA2-PSK (Pre-Shared Key).
