iB-WRX150NE
150M Extreme Wireless-N Router
- 4 -
1.4 Panel Layout
1.4.1 The Front Panel
Figure 1-1 Front Panel sketch
WPS/Reset
：
There are two ways to reset to the Router's factory defaults:
1) Use the
Factory Defaults
function on “
System Tools
→
Factory Defaults
” page in the
Router's Web-based Utility.
2) With the Router powered on, hold the
WPS/Reset
button (more than 5 seconds) until the
SYS LED becomes quick-flash from slow-flash. And then release the button and wait the
Router to restart to its factory default settings.
The Router’s LEDs and the WPS button are located on the front panel (View from left to right).
Name
Status
Indication
Off
Power is off.
Power
On
Power is on.
On
The Router is initializing.
Flashing
The Router is working properly.
System
Off
The Router has a system error.
Off
The Wireless function is disabled.
WLAN
Flashing
The Wireless function is enabled.
Off
There is no device linked to the corresponding port.
On
There is a device linked to the corresponding port but
there is no activity.
WAN,
LAN 1-4
Flashing
There is an active device linked to the corresponding port.
Slow Flash
A wireless device is connecting to the network by WPS
function. This process will last for about 2 minutes.
On
A wireless device has been successfully added to the
network by WPS function. The LED will keep on for about
5 minutes.
WPS
Quick Flash
A wireless device failed to be added to the network by
WPS function.
Table 1-1 LEDs Description
Note:
1. After a device is successfully added to the network by WPS function, the WPS LED will
