iB-WRX150NE
150M Extreme Wireless-N Router
- 6 -
Chapter 2
Connecting the Router
2.1 System Requirements
Broadband Internet Access Service (DSL/Cable/Ethernet)
1 DSL/Cable Modem that has an RJ45 connector (which is not necessary if the Router is
connected directly to the Ethernet.)
Computer with a working Ethernet Adapter and an Ethernet cable with RJ45 connector
TCP/IP protocol on each PC
Web browser, such as Microsoft Internet Explorer, Mozilla Firefox or Apple Safari
2.2 Installation Environment Requirements
Place the Router in a well ventilated place far from any heater or heating vent
Avoid direct irradiation of any strong light (such as sunlight)
Keep at least 2 inches (5 cm) of clear space around the Router
Operating Temperature: 0 ~40 (32 ~104 )
℃
℃
℃
℃
Operating Humidity: 10%~90%RH, Non-condensing
2.3 Connecting the Router
Before installing the Router, make sure your PC is connected to the Internet through the
broadband service successfully. If there is any problem, please contact your ISP. After that, please
install the Router according to the following steps. Don't forget to pull out the power plug and keep
your hands dry.
1. Power off your PC, Cable/DSL Modem, and the Router.
2. Locate an optimum location for the Router. The best place to install is usually at the center of
the area for better network connectivity.
3. Adjust the direction of the antenna. Normally, upright is a good direction.
4. Connect one end of Patch cord to the PC(s) and another end of the Patch cord cable to the
each Switch/Hub in the LAN Ports on the Router, shown in Figure 2-1. (If you have the
wireless NIC and want to use the wireless function, you can skip this step.)
5. Connect the DSL/Cable Modem to the WAN port of the Router, shown in Figure 2-1.
