Iarp GAMMA 150 N, Use And Maintenance

Page: 7 / 24

- 7 -
For a good preservation of the cabinet's body a periodical cleaning is necessary .
EXTERNAL BODY : When necessary, the external body should be cleaned with a cloth and a neutral soap
and water solution.
STAINLESS STEEL SURFACES
: wash with warm water and mild detergent, rinse well and dry with soft
cloth. Avoid scouring pads etc. which will spoil the finish of the stainless steel.
SURFACES IN PLASTIC MATERIAL : wash with warm water and mild detergent, rinse well and dry with
soft cloth; under no circumstances should alcohol, methylated spirits or solvents be used.
GLASS SURFACES : only use products specifically designed for glass cleaning ; it is not advisable to
use ordinary water which can leave a film of calcium on the surface of the glass.
PERIODICAL MAINTENANCE
Any further adjustments on the refrigerator necessarily require the electric plug to be removed.
Check periodically the supply cable in order to detect any damage. If the power supply cable is damaged,
don't use the equipment and don't try to repair it: to prevent any risk, it must be replaced by the manufacturer,
by a member of the after-sales service staff, or anyway by a person having similar qualifications. In any case,
none of the protective elements (the grill, the carter) must be removed by non qualified staff. Absolutely avoid
using the refrigerator without such protection.
The replacement of neon tubes (GAMMA S) must be
carried out only by an Authorized Service Center.
MANUAL DEFROSTING AND TANK CLEANING
To always reach the highest efficiency, the refrigerator needs manual defrosting whenever the frost is over
5 mm thick. Proceed as follows:
1) Place the product in special refrigerated
containers, kept at the same temperature.
2) Turn off the refrigerator by operating main
switch and unplug the unit.
3) Put a basin of warm but not boiling waterinto
the tank and close the glass lids for about 30 minutes.
4) Rotate the lower draining tubes externally,take
the draining taps off from the inner tank and
from the tubes and put a basin under them
to collect water.
5) Carefully wash the tank with water and neutral
soap; rinse and dry well.
6) Plug in again and wait till the appliance reaches the
right temperature before filling it again.
Do not use jet of water to clean the cabinet: electrical
wiring could be damaged.
Never use mechanical devices or any other means to accelerate the defrosting process, other than
those recommended by the manufacturer.
G B
SEASONAL USE
When the unit is not used for a long time, please take note of the following procedures:
-unplug the unit;
-clean and dry the tank well;
-leave the tank open to avoid possible formation of bad smells;
-cover the unit with a curtain, place it in a dry room and sheltered from the atmospheric agents.