Iarp GAMMA 150 N, Use And Maintenance

Page: 6 / 24

- 6 -
Cabinet must be installed on a perfectly even surface, far
away from any heat source (radiators, stoves, etc) including
sun rays.
Good running of the cabinet can be compromised in cases
where the airflow is disturbed (wind, ventilators, air
conditioning outlets, etc).
Smooth running of the cabinet is assisted when sufficient
air is permitted to flow through the bottom of the unit; it
is very important that the grills at the base are kept
uncovered. Do not expose the cabinet to rain.
Install and position the unit in such a way so as to allow
easy access to the power socket.
Never use electrical equipment in the refrigerated
compartment
Never place containers of liquid on or immediately
above the ticket counter; should the content spill out, it would damage the counter.
THE REFRIGERATOR IS NOT SUITABLE FOR WORKING IN DANGEROUS ENVIRONMENT
WITH RISK OF FIRE, EXPLOSIONS OR RADIATIONS.
Operation is regular with ambient temperature indicated on technical data plate.
INSTALLATION
Remove the packaging completely; clean the cabinet using
warm water with a 5% concentration of neutral soap. Be
sure to use a soft cloth for drying. Note that only specific
product can be used for the glass, e.g. some types may leave
behind limestone residues.
INFORMATIONS ABOUT USE
PUTTING INTO OPERATION
Check that the voltage on the identification plate is the same
as that of the network.
THE ELECTRICAL SUPPLY LINE TO WHICH THE
REFRIGERATOR WILL HAVE TO BE CONNECTED
IS TO BE PROTECTED BY A VERY SENSITIVE
DIFFERENTIAL SWITCH (Rc=16A,Dc=30mA); IT IS
ALSO TO BE LINKED TO THE GENERAL EARTHING
PLANT.
The manufacturer disclaims all responsability for any damage
to people or
things due to incorrect observance of this rule.
Earthing is necessary and compulsory by law. Absolutely
never use reduction units, patch cords, adapters or
multiple socket outlets to connect the counter.
DIRECTLY connect the equipment to the mains.
. After plugging, wait till the appliance reaches the right
temperature before filling it; don' t place the product over the max. load level.
G B