IAI IF, Operating Manual

Page: 16 / 48

I NTELLIGENT ACTUATOR
6. Installation and Storage Environments
6.1 Installation Environment
The actuator should be set up in an environment which meets the following criteria:
6.2 Storage Environment
The storage environment should be similar to the operating environment. In addition, you must take precautions
against condensation if the unit is to be stored for a long period of time.
Unless there are special instructions, we do not include moisture absorption agents when shipping the unit. If you are
storing the unit where condensation might occur, then you must treat the entire packing or treat the unit itself after it is
unpacked to prevent condensation.
The unit can withstand up to 60ºC during a short storage interval but only up to 50ºC if the storage period is longer than one
month.
• Avoid direct sunlight.
• Avoid radiant heat from strong heat sources such as a furnace.
• Ambient temperature should be 0 ~ 40º C.
• The humidity should be less than 85% and there should be no condensation.
• Avoid exposure to corrosive or combustible gases.
• The area should have very little dust and be suitable for normal assembly operations.
• Avoid exposure to oil mist or fluids used in cutting.
• The unit should not be subject to vibrations greater than 0.3G.
• Avoid surroundings with extreme electromagnetic waves, ultraviolet rays and radiation.
In This product, any chemical resistance has not been considered. In general, the environment should be one in which an
operator can work without protective gear or clothes.
6