5
4.
Install the Motor Cover / Pump to the back of the Modesty Panel. There are five threaded
inserts in the front of the Motor Cover that line up with five slots on the Modesty Panel.
Attach
with five 1/4-20 x .75 hex head bolts (Item A) and 1/4 flat washers (Item B).
5.
Place the worksurface on top of the frame and loosely attach it to the beam and pedestal
legs as well as the three screws for the motor cover using the #14AB x .625 screws (Item P)
and 1/4 washers (Item B) screwed into the 3/16 pilot holes drilled in the bottom of the
worksurface. Do not tighten completely as some adjustment will be needed later
.
NOTE:
Before attaching the worksurface, make sure that the hydraulic lines and the switch
cable will not be pinched or crushed by the Modesty Panel.
6
.
Square the frame up on the worksurface and tighten up all fasteners. Be careful not to over
tighten as the screws may strip out
.
