4
Step 1
Step 2
QV-All American Series
Upright Assembly
NOTE:
Drawing below shows the assembly of the uprights to the bench with just the rear leg supports of the
bench for assembly purposes, it is recommended that you install the uprights after the assembly of your
bench.
Step 1
- Insert the upright caps into the top of the uprights.
Step 2
-
NOTE: See the next page for directions on where to drill through holes for your uprights.
Once the holes have been drilled, you are now ready to install the uprights. Take one upright and align the
holes on the work surface to the holes that are at the bottom of the upright. Using the BOLT 3/8-16 X 2.50
FULL THREAD BLACK along with WASHER 3/8 FLAT ZINC thread the bolt through the slot in the upright
and down through the work surface. Tighten the bolt using the NUT 3/8-16 HEX KEPS BLACK and both of
the washers, the flat black washer, and also the 3/8 flat zinc washer. Now take BOLT 3/8-16 X 2.50 FULL
THREAD BLACK and the 3/8 flat zinc washer. Thread them up into the work surface and into the upright and
tighten the hardware. Make sure all hardware is tightened and secure.
