4
QS-All American Series Electrical
Follow Steps 1 and 2 to install mounting bracket to worksurface.
PLEASE NOTE:
(If installing electrical channel on the underside of worksurface)
Place worksurface top side down on smooth flat surface being sure to protect it from damage by foreign
objects. If adding electrical channel to an existing or set-up bench, the worksurface will need to be removed
from the frame for it to be able to install on the underside of bench. Once this is done, then the worksurface
needs to be reinstalled to frame.
IAC recommends the use of packing type blankets or clean cardboard.
STEP #1)
Mount one of the metal plates using 2 of the 4 screws given in the hardware kit. To insure proper
alignment only install one of the plates. Then slide electrical onto mounting plate until there is space to mount
the remaining mounting plate.
STEP #2)
Once the second mounting plate is installed slide the electrical back onto the second mounting plate. The
electrical duplex should be connected to the two mounting plates on the work surface.
