4
Step 1
Step 2
Step 1
Step 1
QV-All American Series
LT Light Fixture Assembly
Step 1
-
Read the Note below before continuing
. Once the Bolts, 1/4-20 X 1.00 HH BLACK and 1/4 flat
washers have been threaded through the slots in the light fixture, proceed to feed the Nut, 1/4-20 UNISTRUT
SHORT SPRING N-5 into the sides of the unistrut channel by compressing the spring and rotating the nut
inside the channel until it sets along the inside of the channel. Once the Nut Springs are lined up with the
Screws in the light fixture, you may tighten the screws, connecting the unistrut channel to the light fixture.
Making sure the hardware is securely tighten you can now put back together the light fixture diffuser and
ballast cover back together. Also you may insert the Caps, 1.25"X1.25" 16GA BLACK into the end of the light
support beams.
Note:
The light fixture diffuser and ballast cover must be removed to expose the mounting slots in
the light fixture housing. This must be done with extreme caution so that neither part is broken nor
that wires are not exposed when the ballast cover is reinstalled.
Step 2:
Using Bolts, 1/4-20 X 1.00 HH BLACK and 1/4 flat washers provided, feed them into the two support
channels through the bottom of the uprights connecting the light fixture/channel assembly to the two supports.
Make sure all hardware is fully tightened and secure. At this time you may snap your Light fixture assembly
into the slotted uprights at the desired height.
