4
Reference Assembly Drawing below:
It may take as many as 4 people to assemble this bench.
1.
Place worksurface (item 1) on clean surface underside facing up to be installed later. Install
the four floor glides (item J) and the four black bottom end cap (item H) to each end of the
leg assemblies.
2.
Loosely attach front beam (item 3) to leg assemblies (item #2) using (item D)
Bolt, ¼-20 x
.750 SQH Black GR2
and Washer 1/4 Flat black (item B).
3.
Loosely attach modesty panel (item 4) to leg assemblies using three 1/4-20x3/4 square
head bolts (item D) in the rear slots of each of the legs (note: Square head bolts slides into
the rear of the aluminum channels) and1/4 flat washers (item B) and 1/4-20 hex nuts (item
C). Then, at the top of each end of the modesty panel is another slot that aligns with a hole
in the worksurface support at the top of each leg (item 2). Use a hex head bolt, two washers
and a hex nut to attach at each top end (items A, B, and C).
