9
Rev.
150505
i3-TRNG-CAMS-
68R_78R
.indd
Important. Please Read:
•
Use sealant at the locations shown on the mounting diagrams to maintain
IP66 rating when installing outside.
•
It is the installer’s responsibility to ensure that the mounting surface is
suitable for the chosen installation method.
•
Based on installation location and surface type, supplied screws and
anchors may not be adequate.
•
Mounting hardware is site-specific and may need to be supplied by the
installer.
1
1
1
TOP
Drill Template
Hole A : for cables routed through the ceiling
Screw hole 1 : for Mounting Base
Figure 8. Surface Mount Template
3.3 Surface Mounting
1. Use the Surface Mount
Template to drill three (3)
6 mm (0.2”) screw holes at the
marked template positions on
the mounting surface.
2. Drill the cable opening at the
marked template position.
129.5
112.1
ø
30
3. Insert three (3) supplied screw
anchors into the drilled holes in
the mounting surface.
4. Use a Phillips screwdriver to insert
supplied screws into the screw
anchors. Leave enough screw
length protruding from the each
anchor to allow for the camera
body to be rotated onto the
screws.
Figure 9. Surface Mount - Steps 3-4.
