15
Rev.
150505
i3-TRNG-CAMS-
68R_78R
.indd
3.6 Wall Mount w/ Back Box
Note on supplied mounting hardware and IP66 rating
Based on installation location and surface type, supplied screws and
anchors may not be adequate. Mounting hardware is site-specific
and may need to be supplied by the installer.
It is the installer’s responsibility to ensure that the mounting surface
is suitable for installation method.
Use sealant at the locations shown on the mounting diagrams to
maintain IP66 rating when installing outside.
1. Install the i3 Back Box (DB78BB) on
the wall surface using the hardware
and instructions supplied with the
angle mount bracket. Use silicone
sealer as indicated on the diagram to
maintain IP66 rating when installing
outside.
Use
silicone
to maintain IP66
rating
DB78BB - Back box
Use
silicone
to maintain IP66
rating
DB78BB - Back box
2. Remove the camera cover. Use a
Phillips screwdriver to loosen the
safety lock screw, then grip the
camera cover and flex on one side,
towards the center.
Lift UP to remove.
3. Use a Phillips screwdriver to insert
three machine-type screws provided
with the DB78BB back box into the
screw holes on the back box. Leave
enough screw length protruding to
allow for the camera body to be
rotated onto the screws.
4. Feed the camera cabling through the
back box opening.
Figure 23. Angle-Mount - Step 1.
Figure 24. Angle-Mount - Step 3.
