11
Rev.
150505
i3-TRNG-CAMS-
68R_78R
.indd
3.4 Wall Mount w/ Back Box and Gooseneck Bracket
1. Install the i3 Goose-neck
bracket (DB60) on the wall
surface using the hardware
and instructions supplied
with the goose-neck bracket.
Note on supplied mounting hardware and IP66 rating
Based on installation location and surface type, supplied screws and
anchors may not be adequate. Mounting hardware is site-specific
and may need to be supplied by the installer.
It is the installer’s responsibility to ensure that the mounting surface
is suitable for installation method.
Use sealant at the locations shown on the mounting diagrams to
maintain IP66 rating when installing outside.
Use
silicone
to maintain IP66
rating
DB60 - Goose-neck
Bracket
DB78BB - Back box
Safety lock screw
2. Attach DB78BB back box to the
threaded end of the goose-
neck bracket DB60 and rotate
clockwise to attach the two
together. Use silicone sealer
as indicated on the diagram
to maintain IP66 rating when
installing outside.
Use
silicone
to maintain IP66
rating
DB60 - Goose-neck
Bracket
DB78BB - Back box
Safety lock screw
3. Remove the camera cover.
Use a Phillips screwdriver to loosen
the safety lock screw, then grip
the camera cover and flex on one
side, towards the center. Lift UP to
remove.
4. Use a Phillips screwdriver to insert
three machine-type screws provided
with the DB78BB back box into the
screw holes on the back box.
Leave enough screw length
protruding to allow for the camera
body to be rotated onto the screws.
Figure 13. Wall-Mount - Step 2.
Figure 14. Wall-Mount - Step 4.
