Changing the Battery
The thermometer is supplied with one lithium cell (CR2032). A low battery symbol will appear on the LCD
when the battery needs to be replaced. Power off the thermometer prior to replacing the batteries.
1. Open the battery cover: Insert a pointed object, such as a pen, into battery cover pick hole. At the
same time, use thumb to push battery cover out.
2. Hold the device and flip the battery out with a small screwdriver
3. Insert the new battery under the metal hook on the left side and press the right side of the battery
down until you hear a click. * The positive (+) side up and the negative (-) side pointed down.
4. Replace the battery cover
The thermometer may be damaged when changing the battery while powered on, turn the thermometer off prior to replacing
batteries. Properly dispose of used batteries and keep out of reach of children.
Troubleshooting
Error
Message
Problem
Solution
Device stabilization in process.
Wait until stops flashing.
Battery is low and no more
measurements are possible.
Replace the battery.
Measurement taken before
device stabilization.
Wait until stops flashing.
The device showing a rapid
ambient temperature change.
Allow the thermometer to rest in a
room for at least 30 minutes at
room temperature:
50
o
F ~104
o
F (10
o
C and 40
o
C).
The ambient temperature is not
within the range of: 50
o
F ~104
o
F
(10
o
C and 40
o
C).
Allow the thermometer to rest in a
room at least 30 minutes at room
temperature: 50
o
F ~104
o
F (10
o
C
and 40
o
C).
Error 5~9, the system is not
functioning properly.
Remove the battery, wait for 1
minute and reinsert. If the message
reappears, contact the retailer for
service.
Temperature taken is higher than
108.0
o
F (42.2
o
C).
Check the integrity of the probe
cover and take a new temperature
measurement.
Temperature taken is lower than
93.2
o
F (34
o
C).
Make sure the probe cover is clean
and take a new temperature
measurement.
Device can not be powered on to
ready stage.
Replace with a new battery.
