3-5
IN CASE OF EMERGENCY
SD070E1-E
3. Loosen Wheel Nuts
The wheel nuts should be loosened slightly be-
fore raising the car. To loosen the nuts, turn the
wheel brace counterclockwise. Ensure that the
wheel brace socket is seated properly on the nut
and that it cannot slip. Do not remove the nuts at
this stage.
SD070F1-F
4. Put the Jack in Place
The base of the jack should be placed on firm,
level ground. The jack should be positioned as
shown in the drawing.
HGK193
HGK186
D060F02E-EAT
5. Raising the Car
After inserting a bar into the wheel nut wrench,
install the bar into the jack as shown in the draw-
ing. To raise the vehicle, turn the wheel nut wrench
clockwise. As the jack begins to raise the vehicle,
double check that it is properly positioned and will
not slip. If the jack is on soft ground or sand, place
a board, brick, flat stone or other object under the
base of the jack to keep it from sinking.
Raise the car high enough so that the fully inflated
spare tire can be installed. To do this, you will need
more ground clearance than is required to remove
the flat tyre.
WARNING:
Do not get under the car when it is supported
by the jack! This is very dangerous as the jack
could fall and cause serious injury or death.
No one should stay in the car while the jack is
being used.
HFC4022
Wrench bar
Wheel nut wrench
