CONTROLS AND EQUIPMENT
1- 40
3. Push and turn the wrench counterclockwise
to open or clockwise to close the sunroof.
B460D03GK-AAT
Manual Operation of Sunroof
If the sunroof does not electrically operate:
HGK032
1. Remove the cap located in the rear roof panel
by using a coin or driver.
2. Insert the hexagonal head wrench provided
with the vehicle into the socket. This wrench
can be found in the vehicle's boot or glove
box.
HGK033
CAUTION:
o Do not open the sunroof in severely cold
temperature or when it is covered with ice
or snow.
o Periodically remove any dirt that may
have accumulated on the guide rails.
B460C01GK-GAT
Tilting the Sunroof System
HGK031
The sunroof is moved to its fully tilt up position by
pushing the "UP" switch, and to stop at the
desired position, push in any switches (Open,
Close, Up, Down).
To tilt down, press and hold the "DOWN" button.
Release the button when the sunroof reaches
the desired position.
NOTE:
After washing the car or after there is rain, be
sure to wipe off any water that is on the
sunroof before operating it.
B460E02GK-GAT
Resetting the Sunroof System
If the battery has been recharged, disconnected
or if the sunroof is operated with the hexagonal
head wrench manually, you may need to reset
the sunroof.
To do this;
1. Turn the ignition switch "OFF".
2. With pressing "open" "up" button at the same
time, turn the ignition switch "ON".
The resetting is failed when the ignition
key to the "OFF" within 1.5 seconds.
3. If the sunroof is set like this, the sunroof is
reset with tilting up/down automatically once
for all.
CAUTION:
If the sunroof is not reset, it may not be
operated properly.
