DO-IT-YOURSELF MAINTENANCE
6-21
SPECIFICATION:
"H"
Horizontal center line of headlights from ground:
Low Beam: 679mm (26.7 in.)
High Beam: 672mm (26.5 in.)
"W"
Distance between each headlight center :
Low Beam: 1,202mm (47.3 in.)
High Beam: 966mm (38.0 in.)
"L"
Distance between the headlights and the wall
that the lights are tested against : 3,000 mm
(118 in.)
G290B01GK-GAT
Adjustment After Headlight Assembly
Replacement
G290B02Y
Vertical
line
Cut-off line
Ground line
Horizontal line
L
W
H
H
"P"
30 mm ( 1.18 in.)
If the vehicle has had front body repair and the
headlight assembly has been replaced, the
headlight aiming should be checked using an
aiming screen as shown in the illustration. Turn
on the headlight switch.
1. Adjust headlights so that main axis of light is
parallel to center line of the body and is
aligned with point "P" shown in the illustra-
tion.
2. Dotted lines in the illustration show the cen-
ter of headlights.
1. Keep all tires inflated to the correct pres-
sure.
2. Place the vehicle on level ground and press
the front bumper & rear bumper down sev-
eral times. Place vehicle at a distance of 3m
(118 in.) from the test wall.
3. See that the vehicle is unloaded (except for
full levels of coolant, engine oil and fuel, and
spare tire, jack, and tools).
4. Clean the head light lenses and turn on the
headlights.
5. Open the hood.
6. Draw the vertical line (through the center of
each headlight beam pattern) and the hori-
zontal line (through the center of each head-
light beam pattern) on the aiming screen.
And then, draw a parallel line at 30 mm (1.18
in.) under the horizontal line.
7. Adjust each cut-off line of the low beam to
the parallel line with a phillips screwdriver -
VERTICAL AIMING.
8. Adjust each cut-off line of the low beam to
each vertical line with a phillips screwdriver
- HORIZONTAL AIMING.