Full Outdoor 2+0 XPIC IP Link
Page 20 of 39
Version
1.0
parameter. In that case is the radio part automatically muted when abnormal transmission conditions are
detected by the device.
•
ATPC Function – Automatic Transmit Power Control enables or disables the ATPC feature. The
transmitted power is automatically adjusted to ensure that the optimum RxLevel (ATPC RxL) is received a T
the remote side (hitless regulation).
•
ATPC RX Level - Required level for Automatic Transmit Power Control. Field specifies the optimal
receive level used for the ATPC function.
MODEM
•
Modem Sync – Demodulator synchronization status is the basic indicator of proper function of the
device’s receiver
◦
ok – It indicates that demodulator is synchronised with received air-frame
◦
loss – It indicates that demodulator is not synchronised with received air-frame
◦
n/a – Not available due to lack of RF/management connection to the remote side
•
XPIC Function - XPIC allows the assignment of the same frequency to both vertical & horizontal po-
larization or in other words to operate both radio channels witin the same frequency.
•
Bandwidth – the bandwidth of the transmitting modulation. The number after the underscore indi-
cates the variant of the modulation.
•
Max RxACM Profile – The highest possible modulation a T given bandwidth. While the ACM func-
tion is enabled this value will be the highest possible modulation, otherwise this will be the actual modula-
tion. Each modulation can have multiple Forward Error Correction variants:
◦
medium – optimal FEC, medium throughput speed
◦
strong – strong FEC, lowest throughput speed
•
MUX sync – This box displays the actual Packet MUX synchronization status.
•
ACM Setting – Gear icon indicates that the ACM settings does not match the factory defaults and
leads the user to the ACM settings. If the ACM is set do defaults such information will be displayed instead.
•
Advanced Setting - Link to the advanced radio settings.
4.5.2
Analyser
Integrated spectral analyser for free channel lookup, or alternatively for detection of interference within
the particular band.
This GUI section consists of two frames:
SPECTRUM ANALYSER
The spectrum analyser configuration frame.
•
Local TX Mute Duration – TX Mute Duration in seconds for the Frequency analyser
•
Delay Before Start - Delay before start of frequency analysis in seconds
www.hypercable.fr www.e-rake.fr