Hypercable TwinRadio HYC-Wi 2000, User Manual, Page: 10 / 40

Full Outdoor 2+0 XPIC IP Link
Page 10 of 39 Version 1.0
1.4 Power supply
The device could be powered up in two different ways. This could be either over POE (port LAN2-
POE), or through isolated power supply over separate power supply connector DC-IN.
2 Management Introduction
2.1 Management access
By default is the local SPU unit’s management access bounded to the LAN2 ETH+POE port further refer-
enced by the unit’s SW perspective as LAN2 . In order to connect to the unit for the first time you have to
setup your PC’s network interface (NIC) IP address into the subnet corresponding to the unit’s default IP
address range and interconnect both PC and the unit by an appropriate Ethernet cable.
Example
Assuming that the unit has the default secondary IP address of 10.10.10.10/24 you will have to setup the
managing computer’s IP address in the network 10.10.10.0 with net-mask 255.255.255.0 (/24 in UNIX no-
tion). Note that the computer’s IP address must not be the same as the device’s IP address. In this case val-
id IP addresses are within range from 10.10.10.1 to 10.10.10.254, except for 10.10.10.10.
Available access methods
Method Port number Example
WEB GUI interface
80 (http),
443 (https)
In your WEB browser enter address “https://10.10.10.10/”
where the IP part corresponds to the unit’s IP address
Secure Shell (ssh) 22 In your ssh/Telnet/SNMP client application enter the unit’s IP
address, credentials and confirm possible security notifications.
Note that the SNMP access is not enabled by default so this op-
tion is not suitable for the initial connection.
Telnet 23
SNMP 161
Please note that connecting to the http protocol (port 80) will result in automatic browser redirection to
the secured https protocol (port 443).
The whole process of initial connection
1. Setup your computer’s network adapter IP address according to the unit’s default IP
2.
Interconnect the unit’s management port and PC by an Ethernet cable
3.
Power up the unit if not already
4.
Connect to the unit from your computer by one of the available methods
For the default IP addresses and credentials please refer to the section Connection and Login.
www.hypercable.fr www.e-rake.fr
info@hypercable.fr