MultiSystem 5060
Operating Instructions Manual
© Hydrotechnik GmbH • All rights reserved
Rev. 1.8/120307EN
Page 53 of 55
8
Cleaning and maintenance
8.1 Cleaning
Attention
Damage to the instrument is possible!
Switch the instrument off and cut-off the power supply BEFORE start-
ing to clean. This prevents the risk of a short-circuit, and thereby
possible damage to the device.
Attention
Damage to the instrument is possible!
Do NOT use any aggressive cleaning materials, solvents, benzin or
similar chemicals when cleaning the device. This prevents the risk of
damage to the casing and/or dulling the display.
•
If the casing becomes dirty, wipe it with soft, slightly damp cloth.
•
Any ingrained dirt can be removed with a mild household cleaning
product.
8.2 Maintenance
This device is maintenance-free. However, it is still essential to regu-
larly re-calibrate it. If the device is in continuous use, we recommend
re-calibration every 2 years.
Hydrotechnik has an efficient calibration laboratory, please contact:
Hydrotechnik GmbH
Holzheimer Straße 94-96 • D-65549 Limburg
Tel.: +49 (0) 6431 – 4004 0 • Fax: +49 (0) 6431 – 45308
E-Mail: [email protected] • Internet: www.hydrotechnik.com
8.3
SD card replacement
Series of measurement, test runs, databases and projects are stored
on the SD card. It can be replaced as follows:
Attention
Compatibility problems with different firmware versions!
If you want to use a SD card with data of the MS 5060, these data
must be created with an instrument with the identic firmware version
like your MS 5060. Otherwise the data cannot be read. The SD card
would have to be formatted what deletes all data.
1. Loosen the two holding screws of the battery cover.