MultiSystem 5060
Operating Instructions Manual
© Hydrotechnik GmbH • All rights reserved
Rev. 1.8/120307EN
Page 37 of 55
A Amplitude of the curve
O Offset between zero and the center line of the curve
F Frequency (“duration” of the curve)
Highlight the curve values, press
and enter the desired values.
The volt values are entered as multiples of 10 mV and frequency val-
ues as multiples of 10 mHz. 2000 results in 20.00 V and 20 results in
0.20 Hz. Press
to confirm the entry.
Press to display the 2
nd
configuration page.
Program channels
Three channels are required to display the measuring values coming
from the load valve. Highlight the desired measurand, press
and
enter the desired special channel. Confirm the entry with
and
leave the submenu by pressing
.
Operation of the load valve
After programming you should return to the main menu, highlight
“Load valve” and press
CONFIG to transmit the settings to the
load valve. Return to the measuring value display, the channels pro-
grammed for the load valve will be shown there.
Now the function bar at the lower screen edge has multiple occupa-
tions. Press
to toggle the occupations:
Standard function bar
2
nd
function bar during operation mode “Ramp” or “Sine”
2
nd
function bar during operation mode “Manual”; the barchart indi-
cates how the valve is opened/closed (here: ~50% open)
The special function bars contain these functions:
START: starts the load valve
STOP: stops the load valve, valve will be closed
closes the valve (operation mode “Manual”, only)
opens the valve (operation mode “Manual”, only)
“freezes” the measuring value display
6.9 Submenu
“Show”
(function bar)
You can process, display and print the stored measured values using
the functions of the show menu.
1. Open submenu “Show”:
2. Select series of measurements:
3. Select output format:
.
4. Set further options (see below).
5. Present series of measurements: