MultiSystem 5060
Operating Instructions Manual
© Hydrotechnik GmbH • All rights reserved
Rev. 1.8/120307EN
Page 40 of 55
6.9.7
Presentation type graph
The selected channels are displayed with the assigned symbols and
colors. You can use the zoom function to enlarge certain areas of the
graph:
1. Enable zoom function:
A yellow rectangle indicates the area that will be enlarged. You can
move and scale the rectangle:
2. Move
rectangle:
3. Scale
rectangle:
4. Display yellow area (apply zooming):
You can use the zoom function repeatedly to show the desired area of
the graph in an optimised way. Then you have the following possibili-
ties:
graph
continue zooming in
zoom out in steps
use spot function (see further below)
toggle
scaling
position
5. End graph presentation:
Change y-scaling
The upper image shows the presentation with y-scaling "GLOSS" that
means the scaling of the displayed channels is shown beneath the
graph beside the channels. This gives more room for the graph.
The y-scaling "Y-AXIS" (lower image) shows the scaling of one chan-
nel at the y axis. Press
to toggle between the scaling of all dis-
played channels. The channel of which the scaling is currently dis-
played is shown beneath the y axis.
Spot function
You can use the spot function to display measured values of a certain
time position within the graph:
1. Activate spot function:
2. Choose move factor:
3. Move spot line:
4. Read measured values.
5. End spot function:
Press the key
during the spot function to select different move
factors.
Delta-spot function
If you press the key
during the graphic is displayed, two new oc-
cupations of the function keys will be displayed:
use d-spot function
screen
In the delta-spot function, two spot lines are displayed. The difference
between the two values marked on the curves by the spot lines is
shown in a rectangle in the upper right corner. Like in the spot func-
tion, you can now choose move factors with the keys
and
toggle between the different calculation methods pressing
.