Hydro-Gear HGM-H Series, Service And Repair Manual

Page: 135 / 280

HGM-E LSHT Wheel Motor 17
Refer to Figure 8
Assembly
1. Before assembly, lubricate all parts with
clean oil and grease rubber parts with clean
petroleum jelly.
2. Using new washers (24), reassemble all
parts in the reverse order of disassembly.
CAUTION: Take care to align the holes of the
end cover (22) with those of the
gear wheel set before inserting the
screws (25).
3. When tightening the screws (25), refer to
the table on page 3 for the required torque
values. Also refer to the torque sequence
illustration on the right for the proper tight-
ening sequence.
NOTE:
As a general rule, use the low end of
the torque specification on fasteners
when reassembling the unit.
Figure 8, End Cover
22
24
25
Gearwheel Set
END COVER
End Cover Screw Torque Sequence
3
5
7
2
4
6
1,8
Ports