Huvitz HOCT-1, User Manual

Page: 15 / 155

HOCT-1/1F
16.
Do not apply excessive force to cable connections. If the cable does not connect easily, make sure that the
connector (plug) is appropriate for the receptacle (socket). If you caused any damage to a cable connector(s)
or receptacle(s), let the damage(s) be repaired by an authorized service technician.
17.
Please do not pull on any cable. Always grab the plug when disconnecting cables.
18.
Before you use, check the exterior of the instrument and its conditions.
19.
Do not block any ventilation outlet necessary for proper heat dissipation.
20.
If smoke, sparks or any abnormal noise or smell is noticed coming from the instrument, please switch the
power off immediately and pull out the plug.
21.
When you carry this product, please use a hand cart. If you want to move the product to other area, please
contact customer service center.
22.
To avoid the risk of electric shock, this instrument must only be connected to protective earth.
23.
Do not place the instrument where it is difficult to operate the disconnecting device. (disconnecting device:
power cable)
24.
The equipment may be impaired if it is used in a manner not specified by the manufacturers or manual.
25.
External equipment intended for connection to signal input, signal output or other connectors of this instrument,
shall comply with relevant IEC Standard (e.g., IEC60950 for IT equipment and IEC60601-1 series for medical
electrical equipment). In addition, all such combination-system-shall comply with the standard IEC60601-1
harmonized national standard or the combination. If, in doubt, contact qualified technician or your local
representative. The operator should not touch the patient and accessible male parts of the SIP/SOP
connectors simultaneously.
26.
When you carry this product, please hold on left(A) and right(B) bottom of the product.