Husqvarna Wacker Neuson CRT60-74LX, Operator'S Manual

Page: 65 / 136

wc_tx004561gb.fm
65
CRT60-74LX Maintenance
6.5 Installing or Changing the Blades
There are two types of blades available for the trowel:
■ Combination blades can be used throughout the entire concrete working
process, from floating to finishing stages. They are designed for rotation in one
direction only.
■ Finish blades are used only in the final stages of the concrete working process.
While in use, these blades are pitched at progressively steeper angles to
burnish the concrete. Finish blades are symmetrical and can be installed to
rotate in either direction.
Perform the procedure below to install replacement blades or to change blades as
needed to suit jobsite requirements.
Requirements ■ Machine is stopped
■ Battery is disconnected to prevent unintentional start-up
■ Machine has been lifted via a hoist, or raised on the wheel kit
■ Frame is supported on blocks while the machine is elevated
■ Combination blades or finish blades for installation
■ Protective gloves
■ Bearing grease
Procedure Perform the procedure below to install or change the blades.
1. Remove the screws (a) from the trowel arms (b) and detach the existing blades
(c) . Set the existing blades aside for future use or dispose of them properly if
they have reached the end of their service life.
This procedure continues on the next page.
WARNING
Cutting hazard. Trowel blade edges are extremely sharp, especially if worn.
► Always wear protective gloves when changing blades.
wc_gr008926
c
d
a
b