Husqvarna Wacker Neuson CRT60-74LX, Operator'S Manual

Page: 58 / 136

wc_tx003645gb_FM10.fm
58
Operation CRT60-74LX
5.18 Using the Wheel Kit
The machine is equipped with two sets of hydraulically positioned wheels.
Lowering the wheels raises the machine and blades off the ground so that the
trowel can be rolled to a new location. Raising the wheels positions the wheels off
the work surface so that the machine and blades may operate.
NOTICE ■ Do not operate the rotors when the wheels are lowered (machine and blades
raised). Damage to the drive motors will occur.
■ Do not use the wheel kit when the machine is on partially cured concrete.
Damage to the work surface may occur.
Requirements ■ Bystanders are out of the way
■ Machine is on a level surface
Procedure Perform the procedure below to use the wheel kit.
6. Start the engine.
7. When the machine is warmed up, set the engine speed to FAST by pressing the
“rabbit” symbol on the engine speed switch (a) .
8. To lower the wheels, press and hold the front of the wheel switch (b) until the
wheels are fully extended.
This procedure continues on the next page.
CAUTION
Possibility of unexpected machine movement.
► Use the wheel kit only when the machine is on a level surface.
a
wc_gr014513
b