7 HANDLEBAR,CONTROLS
7.1
7.2
50
Handlebar �osition
800116-10
On the upper triple clamp, there are two holes at a distance
of
6)
to each other.
I Hole distance A
115 mm (0.59 in)
The holes on the handlebar support are placed at a distance
of
0
from the center.
I Hole distance B
I
3.5 mm (0.138 in)
The handlebar can be mounted in four different positions. In this
way, the handlebar can be mounted in the most comfortable
position for the rider.
Adjusting the handlebar �osition
B00375-10
-
Remove screws
O.
Take off the handlebar clamps. Take off
the handlebar and lay it to one side.
Info
Protect the components against damage by covering
them.
Do not bend the cables and lines.
-
Remove screws
8.
Remove the handlebar supports.
-
Place the handlebar supports in the required position. Mount
and tighten screws
8.
Guideline
Screw, handle-
M10
bar support
40 Nm (29.5 lbf ft)
Loctite
®
243
™
•
Info
I
Position the left and right handlebar supports evenly.
-
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor
rectly.
-
Position the handlebar clamps. Mount and tighten screws
0
evenly.
Guideline
Screw, handlebar
clamp
MB
20 Nm (14.8 lbf ft)
..
