Husqvarna DXR300, Operator'S Manual

Page: 42 / 60

42 –
English
MAINTENANCE AND SERVICE
F
Mountings
General
• Check that all components are properly secured by feeling,
pulling etc. Keep a look out for wear damage. This can be
caused by components coming loose.
• A bolted joint that is secured with adhesive should not be
tightened. Simply check that it is tight. If a glued bolted joint
has come loose, clean the threads before fresh adhesive is
applied.
• Check the shafts with respect to mounting/locking. Check
expanding shafts by tightening with a torque wrench.
• Locking pins must be checked with respect to damage and
mounting.
Shafts
• The design of the expanding shafts ensures that there is not
too much play provided that they are tightened regularly.
New expanding shafts must be tightened frequently until
they have bedded in. Wear damage on the expanding
shaft’s sleeve is a typical sign that they have not been
tightened correctly or sufficiently often.
• If an expanding shaft has slipped out of position it is
important that it is centred before being retightened again.
Tightening torque
Use abutment when torquing through shafts to avoid the shaft
rotating.
Position Nm
A
Gear ring bearings against chassis
beam
81
B Gear ring bearings against base plate 81
C Shafts, arm system, outriggers 175
D Track sides 500
E Tool against adapter plate 197
F Support leg bracket 650