Husqvarna 226R, Workshop Manual

Page: 34 / 58

5
33
503 97 64-01
Angle gear
Assembly
Output shaft
Start putting the bevel gear and the output
shaft together.
1. Place the cogwheel on the shaft.
2. Push the two ball bearings in place.
Dismantle the bearings from the output
and input axles. Dismantle the bearings from the output
and input axles with the help of a small
bearing puller.
TIP!
Hold the bearing puller in a vice so that it
gains a better grip around the bearing.
Clean all components and inspect them for wear and damage. Replace damaged com-
ponents.
NOTE!
Both cogwheels should be replaced at the same time, even if only one of them
is damaged.
Grease the cogwheel thoroughly. 3. Grease the whole cogwheel with a large
amount of gear housing grease 503 97
64-01 as per the picture.
Warm the gear housing to about 140°C
and push the output shaft into the gear
housing. 4. Use a hot air gun to warm the gear
housing to about 140 °C.
5. Push the output shaft into the gear
housing.
Make sure the ball bearings touch bot-
tom in their positions.
If required, use a suitable mandrel.
6. Fit the circlip.