Husqvarna 226R, Workshop Manual

Page: 7 / 58

Starter
1
8
522 43 18-01
Replacing the drive
Dismantle the drive disc anticlockwise.
Replacing the drive
The drive disc is threaded on the crank-
shaft.
To remove it, stop the engine from rotating
by using the piston stop no. 522 43 18-01.
Note that it must be placed on top of the
piston in the combustion chamber.
Loosen the drive disc in an anticlockwise
direction.
NOTE!
The nut is soldered onto the drive
disc.
Replace the drive dog if it is worn or
defective. Replace the drive dog if it is worn or
defective.
Clamp the blades of the drive dog togeth-
er with a pair of pliers and push it out from
the drive disc cup.
Tighten the return spring.
Pull out the starter cord completely and
slow the starter pulley with your thumb.
Lift the starter cord up out of the cut-out
on starter pulley.
Then turn the starter pulley anti-clock-
wise 5 revolutions.
Check the spring tension. With the cord
completely pulled out the cord pulley
should be able to be turned at least an-
other half revolution.
Tighten the return spring.
Check the spring tension.
Fit the starter. Fit the starter on the engine body.
Hold the starter in place and tighten the 5
screws.
Check that the starter works.