Husqvarna 226R, Workshop Manual

Page: 30 / 58

4
29
Centrifugal clutch
Assemble the diff erent components in the
reverse order as set out for dismantling.
1. Warm the clutch cover to about 120°C
before assembling the ball bearing (A).
Assemble the circlip (B) holding the
ball bearing in place.
2. Push the clutch drum (C) in and as-
semble the circlip (D) holding it in
place.
Rub the AV element (E) in with talc to
facilitate the assembly and extend its
service life.
3. Push the AV element into the clutch
cover.
4. Push the lower bracket (F) into the AV
element and then the upper bracket
(G).
5. Assemble the complete clutch cover
on the shaft and make sure the centre
screw (H) can be screwed into the hole
in the shaft.
Check the inside diameter of the clutch
drum. If it exceeds 54,5 mm it should be
replaced. Check the clutch drum for wear.
The diameter must not exceed 54,5 mm. If
this is the case replace the clutch drum.