Hunter GSP9200 Touch, Operation Instructions Manual

Page: 55 / 88

BALANCING PROCEDURES 47
3.15 Optional HammerHead ® TDC
Laser Adhesive Weight Locator
The balancer will find the TDC for the left or right weight
plane if “Servo-Stop” is enabled. “Servo-Stop” will hold
the wheel in the TDC position while the servo-activated
laser automatically locates TDC to aid in fast clip-on
weight positioning.
The HammerHead
®
TDC Laser System automatically
displays a vivid line at top dead center after a wheel has
been spun. The laser turns “off” when the wheel is spun
again.
Use of controls or adjustments or performance
of procedures other than those specified herein
may result in hazardous radiation exposure.
This Laser Product is designated as Class 1M during all
procedures of operation.
Never look directly into the laser. Doing so may cause
serious injury.
Figure 181.
Operation accessible radiation fields:
Wavelength: 635-660nm
Laser Power for Classification: <1mW via 7mm aperture
Beam Diameter: <5mm at aperture
Divergence: <1.5mrad x <2rad
Transverse Beam Mode: TEM00
3.14 BDC Laser Adhesive Weight
Locator
The Servo-Activated Laser automatically locates BDC to
aid in fast adhesive weight positioning.
During the mixed weights and adhesive weights
balancing procedures, the BDC laser locator
automatically displays a vivid line at bottom dead center
after a wheel has been spun. The laser turns off when the
wheel is spun again.
Use of controls or adjustments or performance
of procedures other than those specified herein
may result in hazardous radiation exposure.
This Laser Product is designated as Class 1M during all
procedures of operation.
Never look directly into the laser. Doing so may cause
serious injury.
Figure 180.
Operation accessible radiation fields:
Wavelength: 635-660nm
Laser Power for Classification: <390uW via 7mm
aperture
Beam Diameter: <5mm at aperture
Divergence: <1.5mrad x <2rad
Transverse Beam Mode: TEM00