Hunter GSP9200 Touch, Operation Instructions Manual

Page: 34 / 88

26 BALANCING PROCEDURES
The CenteringCheck® procedure will repeat up to four
times and always compare the previous measurement to
the next check.
If centering is not achieved after four attempts, the
CENTERING FAILURE screen will appear.
Figure 84.
If centering is not achievable, check for:
• Correct collet/adaptor for this wheel design.
• Wheel defect such as a metal burr interfering with the
collet/adaptor.
• Dirt or debris interfering with the collet/adaptor.
Follow the on-screen prompts, and then touch the
“Restart Procedure” button.
Mounting Error Detection Features
To verify that the tire/wheel assembly is centering, re-
mount the tire/wheel assembly and observe the results.
Do any of the following conditions occur?
• Weight amount varies excessively
• Weight location changes
If any of these conditions occur, the centering accuracy of
the tire/wheel assembly needs to be verified.
Spindle-Lok foot pedal to enter the valve stem
position.
Figure 80.
Figure 81.
CenteringCheck® results will appear
If the rim is centered properly, the CENTERING
CHECK PASSED screen will appear.
Figure 82.
The balancer will then return to the main balance screen.
Balancing procedures may now be performed.
If a centering problem is detected, the “off-target” screen
will be displayed.
Figure 83.