Hunter GSP9200 Touch, Operation Instructions Manual

Page: 14 / 88

6 GETTING STARTED
The main power ON/OFF switch is located on the back of
the balancer cabinet. To power the balancer “ON,” press
the “I” side of the ON/OFF switch. To turn all power the
balancer “OFF,” press the “O” side of the ON/OFF switch.
(Figure 8.)
Figure 8.
After the SmartWeight Touch®/GSP9200 Touch
Balancer performs a self-check, the main balance
screen will appear indicating the unit is ready for use.
Figure 9.
Equipment Installation and Service
Only a Hunter Factory-Authorized Representative should
perform installation.
This equipment contains no operator serviceable parts.
All repairs must be referred to a qualified Hunter Service
Representative.
Equipment Specifications
Electrical
Voltage: 10% / -15%, 1
phase, 50/60 Hz, power cable
includes NEMA 20 amp plug,
L6-20P
Amperage: 10 amperes
Wattage: 3450 watts (peak)
Air
Air Pressure Requirements: 100-175 PSI (6.9-12.0 bar)
Approximate Air Consumption: 4 CFM (110 Liters/Minute)
Atmospherics
Temperature: 0°C to +50°C (+32°F to
+122°F)
Relative Humidity: Up to 95% Non-condensing
Altitude: Up to 1829 m (6 000 ft.)
Sound Pressure Level
Equivalent continuous A-weighted sound pressure at operator’s
position does not exceed 70 dB (A).
Explanation of Symbols
These symbols may appear on the equipment.
Alternating current.
Earth ground terminal.
Protective conductor terminal.
l ON (supply) condition.
OFF (supply) condition.
Risk of electrical shock.
Stand-by switch.
Not intended for connection
to public telecommunications
network.