INSTALLATION
5
Mount the Installation Brackets — Outside Mount
■
Center the headrail over the window opening at the desired height. Use a pencil to lightly
mark each end of the headrail.
➤
Alternatively, measure the width of the headrail and use that width to mark the headrail
end points over the window opening.
■
Measure and mark 3" from each end of the headrail.
➤
If more than two installation brackets came with your order, space additional bracket(s)
evenly between the two end brackets and mark the location. Mount into wood whenever
possible.
Allow a minimum of 18" between bracket center lines (motor side) for
the battery wand.
■
Center the brackets on your marks, then mark the screw hole locations.
➤
A minimum 1" flat vertical surface is required.
➤
The top of the installation brackets should be at
the desired height. The brackets must be level
and aligned.
CAUTION:
The rear of the brackets must be flush
against a flat mounting surface. Do not mount brackets
on curved molding.
■
Pre-drill the screw holes using a
3
/
32
" drill bit.
CAUTION:
Use drywall anchors when mounting into drywall.
3"
Window Opening
Space Evenly
Space Evenly
3"
3"
Headrail End Mark
Headrail End Mark
