INSTALLATION
4
Mount the Installation Brackets — Inside Mount
■
Measure and mark 3" in from each jamb (two bracket widths) for bracket location.
➤
If more than two installation brackets came with your order, space additional bracket(s)
evenly between the two end brackets and mark the location. Mount into wood whenever
possible.
Allow a minimum of 18" between bracket center lines (motor side) for
the battery wand.
Recommended Best Practice:
To enhance ease of installation, position the front edge of the
installation bracket approximately
1
/
4
" into the room.
■
Center the brackets on your marks, then mark the screw hole locations.
➤
The minimum casement depth for installation
brackets is 1" (1
3
/
8
" with battery wand).
Mark
the rear set of installation bracket holes with
shallow mounting depths.
➤
The minimum casement depth for a fully recessed
mount is 4" (4
1
/
2
" with battery wand).
Mark the
front set of bracket holes when depth permits.
IMPORTANT:
For shades with a battery wand, allow
a minimum of
3
/
4
" clearance behind the brackets to
accommodate the wand.
■
Pre-drill the screw holes using a
3
/
32
" drill bit.
CAUTION:
Use drywall anchors when mounting into drywall.
■
Use a level to check that the mounting surface
is level. Shim (not provided) the brackets if
necessary.
■
Attach the installation brackets using the
screws provided.
IMPORTANT:
The front edges of the
installation brackets must align to each other.
For the best experience, mount the brackets
with the front lip outside the window casement.
Proceed to “STEP 2 — Remove the Shipping Clips” on page 7.
3"
Minimum
Casement
Depth 1"
Minimum
1
3
/
8
" with
Battery Wand
3"
Minimum
Casement
Depth 1"
Minimum
1
3
/
8
" with
Battery Wand
Jamb
Jamb
Window Opening
Space Evenly
Space Evenly
3"
3"
