OPERATION
13
Operate the Shade
The shade can be operated using the programming button or the PowerView
®
remote. A single
control is used to operate both the front shade and the back panel. Operation is sequential. The
front shade must be fully lowered before the back panel can be lowered. Conversely, the back
panel must be fully raised before the front shade can be raised.
Test the Shade
Use the programming button to test the shade and ensure that the motor and power source
are working correctly. Each press of the programming button will initiate one of four shade
movements, in sequential order.
1. With the shade in the fully raised
position, press and release the
programming button. The front shade
moves to the fully lowered position.
If the shade does not operate, see
“Troubleshooting” on page 16.
2. Press and release the programming
button a second time. The back panel
moves to the fully lowered position.
3. Press and release the programming
button a third time. The back panel
moves to the fully raised position.
4. Press and release the programming
button a fourth time. The front shade
moves to the fully raised position.
CAUTION:
When raising the shade for the first time, observe how the fabric rolls up into
the headrail. It should roll up evenly. If the bottom rail is not level or the shade starts to rub
against either window jamb, immediately press the programming button to stop the shade. See
“Adjusting the Bottom Rail Weight” on page 18.
Using the PowerView Hub
■
Before setting up the remote, refer to the PowerView Hub Quick Start Guide.
Programming
Button
