INSTALLATION
9
■
STEP 4 — Connect the Power Source
NOTE:
When power is connected to the motor, a green LED inside the programming button
housing will flash to indicate the shade is ready for operation.
■
Refer to the appropriate page based on the ordered power source.
➤
For a battery wand, see below.
➤
For an optional satellite battery pack, see page 10.
➤
For an optional 18V DC power supply, see page 11.
➤
For an optional 18V DC power supply with daisy-chain connections, see page 12.
➤
For an optional C-size satellite battery wand or large DC power supply, see the
instructions that came with the unit.
If You Have a Battery Wand...
Mount the Battery Wand into the Battery Wand Clips
■
Align the battery wand with its socket
toward the motor end on the shade.
■
Push the battery wand straight up into
the battery wand clips until it snaps
into place. Check to make sure the
battery wand is secure.
■
Attach the wire saddle to the headrail
in the area indicated by the dashed
line above.
■
Clip the power cable into the wire saddle, avoiding entanglement with brackets or the shade.
CAUTION:
Be sure the cable does not become pinched by the battery wand clips during
installation. Damage or overheating of components could result.
Plug the Power Cable into the Battery Wand
■
From the back of the shade headrail,
connect the power cable (from the motor
side) into the socket on the battery wand.
Proceed to “Operate the Shade” on page 13.
Socket
Power
Cable
Back of Shade
Socket
Back of Shade
Wire Saddle
