OPERATION
15
■
Press the left arrow or the right arrow to lower the front shade to fully closed and raise the
back panel to fully open.
■
While a shade is in motion, press the opposite of shade motion (
▲
OPEN or
▼
CLOSE) to
reverse direction and move to fully open or fully closed.
■
Press
♥
FAVORITE to send selected shade(s) to your preset “favorite” position. Refer to the
PowerView
®
Motorization Remote Control Guide
on how to set a favorite position. The default
favorite position is the back panel at 50% open.
Further Operation and Programming Information
PowerView Pebble
®
Remote and/or PowerView Surface Remote Operation
For information regarding operation and programming of the PowerView remote, refer to your
PowerView Motorization Remote Control Guide
or to the online PowerView Step-by-Step Guide at
hunterdouglas.com/operating-systems/motorized/powerview-motorization/manuals
.
PowerView Scene Controller
For information regarding operation and programming of the PowerView Scene Controller, refer to
your
PowerView Motorization Scene Controller Guide
or to the online PowerView Step-by-Step Guide
at
hunterdouglas.com/operating-systems/motorized/powerview-motorization/manuals
.
PowerView App Operation
The PowerView Hub is required for PowerView App operation. For information regarding setup
and operation using the PowerView App, refer to the online PowerView Step-by-Step Guide at
hunterdouglas.com/operating-systems/motorized/powerview-motorization/manuals
.
Resetting the Shade (If Necessary)
Calibration Reset
The calibration reset is used to recalibrate the shade’s travel limits.
1. Press and hold the programming button for approximately 6 seconds. The shade will move
slightly. Release the programming button (the light flashes red).
2. Both the front shade and back panel will raise to their fully open positions to reestablish the
upper travel limit, then lower to their fully closed positions to reestablish the lower travel limit.
The back panel will then move slightly twice (up, then down) to indicate that the travel limits were
recalibrated.
Resetting Shade Programming
The programming reset erases all shade programming from memory, including group assignments,
preventing input devices from operating the shade. The primary use is to correct group and network
assignments during installation. The reset does not affect travel limits or the favorite position.
1. Press and hold the programming button for approximately 12 seconds. The shade will move
slightly after 6 seconds, then again after 12 seconds. Release the programming button (the light
flashes red). The light then flashes a series of green and red to indicate that shade programming
is erased from memory.
2. Refer to “Joining a Shade to a Group” on page 14 to program the shade to a group.
