Right:
采样方式：
Sampling mode
采样频率
: Sampling frequency
电波速度
:Electrical wave
滤波方式
: Filter mode
移动选择
Moves selection
Bottom:
设置
:Settings
起点
: Start Point
采样
: Sampling
工作电压
:Working voltage
When all the settings are completed, observe the right of the display screen, and
you can see if a variety of parameters are correct.
3. "Sampling": After setting up the parameters, press "Sampling" key to start sampling.
In the meanwhile it shows countdown waiting time (30 seconds). If there is no trigger
signal waveform to be sampled in 30 seconds, then it will quit. If you want to quit
during sampling, you touch anywhere on the screen when it displays countdown time.
The cursor of the main display can be moved not only by left and right arrows,
but also click the place to move to, you can quickly move the cursor to the destination
point in the main display area. Starting point is green, and the end is white. If you
want to change the starting point, move the white cursor to the point to be reached,
then press "Starting Point" key, and then move the cursor to place the cable distance.
It displays compressed waveform in the upper area of the interface. If you want
to quickly move the cursor to the point you want to see, just press in the picture area,
then the waveform where the cursor is will be displayed in the main display area.
Cursor of main display and cursor of picture area (triangle cursor) is corresponding to
each other, which means green to green and white to white.
You can zoom in/compress waveform in the main display area by "Magnifier"
and "Minifier".
There are five shortcut knots on the right for fast switching function and
parameters. Specific uses are in the main interface introduced before.
