HPE 5820X Series, Configuration Manual

Page: 91 / 512

79
Configuring static multicast routes
By configuring a static multicast route for a given multicast source, you can specify an RPF interface
or an RPF neighbor for multicast traffic from that source. If you want to remove a specific static
multicast route, use the
undo ip rpf-route-static
command. If you want to remove all static multicast
routes, use the
delete ip rpf-route-static
command.
When you configure a static multicast route, you cannot specify an RPF neighbor by providing the
type and number (
interface-type interface-number
) of the interface if the interface of the RPF
neighbor is a Layer 3 Ethernet port, Layer 3 aggregate interface, Loopback interface, or VLAN
interface. Instead, you can specify such an RPF neighbor only by its address (
rpf-nbr-address
).
To configure a static multicast route:
Step Command Remarks
1.
Enter system
view.
system-view
N/A
2.
Configure a
static multicast
route.
ip rpf-route-static
[
vpn-instance
vpn-instance-name
]
source-address
{
mask
|
mask-length
} [
protocol
[
process-id
] ] [
route-policy
policy-name
] {
rpf-nbr-address
|
interface-type
interface-number
} [
preference preference
] [
order
order-number
]
No static multicast route
configured by default.
3.
Delete static
multicast routes.
delete ip rpf-route-static
[
vpn-instance
vpn-instance-name
]
Optional.
Configuring a multicast routing policy
You can configure the router to determine the RPF route based on the longest match principle. For
more information about RPF route selection, see "
RPF check process ."
By configuring per-source or per-source-and-group load splitting, you can optimize the traffic
delivery when multiple data flows are handled.
Configuring a multicast routing policy for the public network
Step Command Remarks
1.
Enter system view.
system-view
N/A
2.
Configure the device to
select the RPF route based
on the longest match.
multicast longest-match
The route with the highest priority
is selected as the RPF route by
default.
3.
Configure multicast load
splitting.
multicast load-splitting
{
source
|
source-group
}
Optional.
Disabled by default.
This command does not take
effect in BIDIR-PIM.
Configuring a multicast routing policy in a VPN instance
Step Command Remarks
1.
Enter system view.
system-view
N/A
2.
Enter VPN instance view.
ip vpn-instance
vpn-instance-name
N/A