384
•
A static member port does not respond to queries from the MLD querier. When you configure an
interface as a static member port or cancel this configuration on the interface, the interface does
not unsolicitedly send any MLD report or an MLD done message.
Configuration procedure
To configure an interface as a static member interface:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter interface view.
interface
interface-type
interface-number
N/A
3.
Configure the interface as a
static member interface.
mld static-group
ipv6-group-address
[
source
ipv6-source-address
]
By default, an interface is not a
static member of any IPv6
multicast group or IPv6 multicast
source and group.
Configuring an IPv6 multicast group filter
To prevent the hosts attached to an interface from joining certain IPv6 multicast groups, you can
specify an IPv6 ACL on the interface as a packet filter. As a result, the receive hosts attached to this
interface can join only the IPv6 multicast groups that the ACL permits.
To configure an IPv6 multicast group filter:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter interface view.
interface
interface-type
interface-number
N/A
3.
Configure an IPv6 multicast
group filter.
mld group-policy
acl6-number
[
version-number
]
By default, no IPv6 group filter is
configured on the interface. That
is, hosts on the current interface
can join any valid multicast group.
Setting the maximum number of IPv6 multicast groups that
an interface can join
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter interface view.
interface
interface-type
interface-number
N/A
3.
Configure the maximum number of
IPv6 multicast groups that the
interface can join.
mld group-limit
limit
By default, the upper limit is
4000 for the HPE 5800
switches, and 1000 for the
HPE 5820X switches.
NOTE:
This configuration only limits the number of IPv6 multicast groups that the interface dynamically
joins.
