B 215 / B 225 Evo
Operator’s manual
83
UK
3
Internal weight
selection/De-
crease
Multifunction key
1. In balancing mode, press this key to select the type
of weight to use on the inner side of the wheel.
2. In the menu press this key to navigate.
3. When entering dimensions manually, press this
key to decrease the displayed value.
4
Menu / Enter
Multifunction key
1. In balancing mode, press this key to access the
wheel balancer menu.
2. In a menu or in a program, press this key to
change the viewed option.
5
Outer weight
selection/In-
crease
Multifunction key
1. In balancing mode, press this key to select the
type of weight to use on the outer side of the
wheel.
2. In the menu press this key to navigate.
3. When entering dimensions manually, press this
key to increase the displayed value.
6
Start
- Press this key to perform a spin.
7
Stop
- Press this key to stop the spin.
1. SWITCHING ON THE MACHINE
Connect the power supply cable (A, Fig.10) sup-
plied with the machine from the external electrical
panel located on the rear side of the wheel balancer
body to the mains.
Switch on the machine using the switch on the rear
side of the body (B, Fig.10).
The wheel balancer performs a checking test (all
the LEDs illuminate), and if no faults are detected,
a beeper sounds and the cycle status initially ac-
tive is displayed, as follows:
- active balancing mode: dynamic (dyn);
- values displayed: 000 000;
- grams displayed in units of 5 (or 1/4 of an ounce);
10
