106
B 215 / B 225 Evo
Operator’s manual
- remove the hub;
- insert the two screws that are supplied in the holes
on the wheel contact flange;
- tighten the screws on the adapter making sure that
it rests on the flange correctly;
- montare l’albero da moto sull’adattatore;
- mount the wheel after selecting the centring cones
(one for each side of the wheel), tighten with the
appropriate ring nut using the spacers necessary for
coupling the securing cones to the threaded part of
the shaft.
- mount the relative extension (Fig.22) on the internal
measuring arm.
- set the wheel data as shown in the paragraph "En-
tering wheel dimensions”.
Important
the wheel must be fixed to the flange so as to avoid any movement of the two during
the spin or braking phases.
Best results can be achieved if the adhesive weights are positioned with the outer
edge flush with the rim edge.
15.2. SET UP – SELECTING THE MODE
FOR ACQUIRING WHEEL DIMENSIONS
IN THE ALU1 AND ALU2 BALANCING
PROGRAMMES (ONLY THE MACHINE
VERSION WITH MANUAL SENSOR)
This configuration is used to select the method for entering dimensions for the ALU1 and
ALU2 programs and as a result the method of applying the adhesive weights inside the rim.
Proceed as follows to recall this programme:
- press the
key
- use the
keys to search for
SEt UP
- press the
key to confirm
- use the
keys to search for ALU P (or ALU St if previously set)
22
